LaneMaster Manual | Using Race Reporter |
Manual Table of Contents | LaneMaster Home Page
To run RaceReporter, click on File, Race
Reporter. (Running it will actually close LaneMaster, and clear all names and data, so
you'll have to re-enter drivers' names into the lanes for the next race.) When Race
Reporter comes up, it will show all the individual race (non-event) files that you have
saved. It also shows (in the view windows) all the descriptive information about the first
race in the race file list. Use the arrow keys to move up and down the list until you find
the race you are interested in. If you press enter when one of the files in the list is
highlighted, or click on any race name, it will automatically switch to "View"
mode and show the results of that race. Use the tab keys to move around between lists and
buttons.
To view entire events rather than single race files click the
"Show Event Files" button. View the individual races in an Event file by
clicking on "Next Group". To change back to viewing race files, click on
"Show Race Files".
Click on the "View", "Print", or
"Delete" button to perform the desired action for that race or event file.
"View" will display the race results just as LaneMaster does at the end of the
race, with all heats and correct colors shown. "Print" will print the race in
the same format as LaneMaster normally does. "Delete" will permanently remove
the file with that name from your hard drive. Be sure to view events before erasing them
so you don't delete the wrong one!
You can also run Race Reporter from DOS without running
LaneMaster, by changing to the \LANEMSTR directory and typing REPORTER (Enter).
This page was last edited on: 09/23/18 |