LaneMaster Manual | Event Mode |
Manual Table of Contents | LaneMaster Home Page
You must go through Qualifying mode to input entrant names
before using Event mode. If you don't want to run qualifying for all or some of your
entrants, you can use "Auto Qualify All" as described above in the section on
Qualifying Mode.
Once you start an event, you must complete it before
starting another one!
When you select the "Event" button or Mode,
Event, if any Event files have been created you will be prompted to select the
class you want to start the event for. If you have not created any Event files yet,
LaneMaster will display a message box telling you to create one!
Once you have chosen the desired class, the names are shown
for the first race. Qualifiers pick the lane they wish to begin the race on, with top
qualifiers (or top finishers after the first round) getting first choice. You may select
the button showing the lane numbers, or you may press the number (or letter in the case of
Round Robin racing) on the keyboard that corresponds to the qualifier's lane choice.
If you wish to add racers, move them around, or edit their
names, this is your last chance before going into the race itself. Double-click on any
name to edit it. For example if "Joe" and "Bob" don't want to be in
the same race for some reason, you could swap them by replacing Joe's name with another
racer's name (who hasn't raced yet!) and letting "Joe" race in place of the
other racer when it's his turn.
(NOTE: If any of the lanes are empty, they will show
"<empty lane>" for the name. Any lane that says "<empty
lane>" can be changed to an actual racer name if you want to add a late-arriving
racer. Just double-click on "<empty lane>" and the "Edit Racer
Name" box will pop up, allowing you to put a real Driver Name in. This DOES NOT apply
to Round Robin racing... you can edit the existing Driver Names, but you cannot add any
racers!)
To show the lane rotation chart when choosing lanes, click on
Show Rotation.
Once all lanes have been selected, click on "OK" to
show the Data view screen. You may then begin the countdown when the racers are in
position, or you may click on Warm Up to turn power on and allow racers to practice before
the race.
The race runs as in Race Mode. At the end you will have the
opportunity to print the results. In Event mode, you are not asked if you want to save the
race results, since they are automatically saved for you. Once the results have been
displayed, printed and saved, the current Move Ups and racers "On the Bubble"
will be displayed. Once you click "OK", you go back to the Lane Selection screen
for the next group of racers.
Just before the first race of each round (including the first
round), you will be shown the currently selected time settings. All races in the same
round must use the same timing, but you may wish to change to longer heats and/or rotation
periods for Semi-Finals or Finals.
After all the races in the event, LaneMaster will
automatically combine all the information from the event into one archive file. Archive
files can later be viewed and/or printed using the "Race Reporter" program
supplied with LaneMaster (see "Race Reporter" below).
Once LaneMaster has finished the event and recorded the data,
you will be given the option to exit the program. If you choose not to exit, LaneMaster
will return to Practice Mode and clear out all Event data. At that point you can create or
modify a class, run another event or just practice. If you choose to exit, LaneMaster will
ask if you want to save any class or event files that have been created, but not used yet.
If you save them, they will be available to run the next time you start LaneMaster. If you
choose not to save them, they will be deleted. Races and events that have already been
completed will not be deleted if you say "Yes". They can and should only
be deleted through "Race Reporter".
This page was last edited on: 09/23/18 |